SuperMoto Junkie banner

Xr600 supermoto build

5K views 10 replies 3 participants last post by  powerhouse4501 
#1 · (Edited)
Bought this bike back in November.. planned on it being a beater that would see occasional street use, but after going through the bike and replacing several parts I decided that it was more fun on the street!

I thought I was done dropping money into it, but after a few rides I noticed the front wheel was cracked and the frame tab for the kickstand tore off... Sigh... So off to the welders and then to powder coat.





Sent from my SM-G930P using Tapatalk
 
See less See more
3
#11 ·
Here are some updated pics. Still gotta figure out the chain slider, finish wiring in the vapor, sort out a rear caliper issue and flush the frame to make sure no blasting media remains before I hook the motor up.
Any ideas on that would be appreciated.

Sent from my SM-G930P using Tapatalk
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top